Description
Integrated Circuit IC Chip Tester Transistor Optocoupler Operational Amplifier Regulator Tube Automatic Identification Device
This multifunctional integrated circuit tester is a professional instrument designed for frontline microelectronics engineers and maintenance personnel. Can choose different test mode 5V mode, 3.3V mode, AUTO mode can test 74HC series, 74LS series, CD4000 series, HEF400 series, 4500 series, operational amplifier, interface chip, optocoupler, transistor automatic identification, voltage regulator value identification and so on. More than 1300 kinds of chip data models and 420 kinds of transistor data models are built in, covering most of the common 24-pin general devices, which can greatly reduce the workload and improve the work efficiency.
TSH series of multi-function integrated circuit tester is a first-line microelectronics engineers, maintenance staff designed professional equipment.
Can choose different test mode:5V Mode / 3.3V Mode / Auto Mode
Operating Instructions
There are seven keys on the panel, which are the up, down, Left, right and Enter keys, and the shortcut keys O and P.
The up and down keys are used to adjust the directory and change the model number. The left and right keys are used to move the cursor around to select the item to be changed. The Enter key is used to switch on and off the PC and run test commands. Open the back cover of the battery, put in 2 # 5 1.5V batteries, then close the battery cover. Press Enter for more than 2 seconds to start, start automatically display the current battery voltage, when the battery power is too low, please replace the battery, too low voltage will affect the reliability of the test results and protection of automatic shutdown.
Power on:
Press Enter for more than 2 seconds to power on.
Shut down:
1 Press the Enter key in the OFF directory to shut down immediately.
2 Press Enter for more than 10 seconds in any directory to shut down.
3 After 60 seconds without any operation, it will automatically shut down.
Quick:
1. Quick shutdown key (Model 06)
2. P key Repeat self-test and reset key
Device placement method is shown as follows:
1. The top of the chip and optocoupler are aligned, and the first foot is aligned with the first foot of the IC seat son.
2. The transistor is placed in the bottom three slots on the left.
3, the voltage regulator is placed between the IC seat 13 and 14 feet.Note: The pin sequence of transistor display from left to right corresponds to the IC seat 10, 11, 12 pins.
